Hi DongInn, This is to let you know that I fixed my issue with Broadcom Netxtreme II card and I successfully installed my node.
If this could be of any help to others.. Problem as I see it (after dozens of tests): The bnx2 driver v. 2.2.1 used onto the master node (came with CentOS 6.3) requests .fw files in /lib/firmware. The.fw files was missing from the initrd.img and the SIS oscarimage. The /lib/firmware files were not included into the SIS oscarimage and therefore not into the initrd.img. After adding them to the initrd.img it was impossible to make the kernel load the .fw files during the PXE boot. Solution: I downloaded the last driver archive Netxtreme2-linux-7.4.27.tar.gz from Broadcom and compiled the drivers. I loaded my new module to check it works onto the master node (same hardware). I copied the bnx2.ko file to the initrd.img UYOK (uncompressed archive) and recreated the image. NOTE: The new bnx2.ko does not depend on any .fw files. I booted PXE and it worked. Thank you for your support. Best Regards, Costel SEITAN ------------------------------------------------------------------------------ Symantec Endpoint Protection 12 positioned as A LEADER in The Forrester Wave(TM): Endpoint Security, Q1 2013 and "remains a good choice" in the endpoint security space. For insight on selecting the right partner to tackle endpoint security challenges, access the full report. http://p.sf.net/sfu/symantec-dev2dev _______________________________________________ Oscar-users mailing list Oscar-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/oscar-users
