Hi Abhinay, Your questions are very implementation specific but since I’m a good guy…
From: OSPF <[email protected]<mailto:[email protected]>> on behalf of Abhinay R <[email protected]<mailto:[email protected]>> Date: Wednesday, July 13, 2016 at 8:11 AM To: OSPF WG List <[email protected]<mailto:[email protected]>> Subject: [OSPF] I have a question regarding forwarding address Hi All, I have a question on when forwarding address is set in external LSA? Suppose I have a route from RIP say 100.1.1.0/24<http://100.1.1.0/24> with nexthop 10.1.1.1 in routing table and I want to redistribute that route into OSPF, then I feel below conditions must be vaild to set 10.1.1.1 as forwarding address in the external LSA that OSPF originates for 100.1.1.0/24<http://100.1.1.0/24> network. These conditions set the forwarding address field to a non-zero address: OSPF is enabled on the ASBR's next hop interface AND Although, it would be a strange topology where it weren’t enabled, it only has to be reachable within the OSPF routing domain as an intra or inter area route. ASBR's next hop interface is non-passive under OSPF AND This should have no bearing on whether the forwarding address is advertised. There could be a better path through the OSPF routing domain independent of whether the interface is passive. ASBR's next hop interface is not point-to-point AND ASBR's next hop interface is not point-to-multipoint AND Although the likelihood of the forwarding address providing a better path is increased for multi-access networks, it is not necessary. ASBR's next hop interface address falls under the network range specified in the router ospf command. Again, the next hop only has to be reachable within the OSPF routing domain as an intra or inter area route. Hope the Helps, Acee Any other conditions besides these set the forwarding address to 0.0.0.0. If I have 10.1.1.0/24<http://10.1.1.0/24> network as intra or inter route in OSPF routing table at the router that imported RIP route, do I originate External LSA with 10.1.1.1 set as forwarding address ? There is a confusion that if the redistributed network nexthop is present in routing table as intra inter or connected route, we need to set it as forwarding address. Please clarify. While we receive a External LSA with forwarding address set, then we see if there is a connected, intra or inter route to that nexthop and then use it to compute the route nexthop. This is clear. Thanks & Regards, Abhinay R
_______________________________________________ OSPF mailing list [email protected] https://www.ietf.org/mailman/listinfo/ospf
