Ilya Maximets via dev <[email protected]> writes: > On 10/23/26 3:47 AM, Aaron Conole via dev wrote: >> Hi Felix, >> >> Felix Huettner via dev <[email protected]> writes: >> >>> Patch 1 just adds a performance test tool that is used throughout the >>> series. >>> >>> Patches 2+3 optimize the cases of non-found connections. This is a >>> common case in combination with OVN for the reverse SNAT and reverse >>> DNAT stages. The performance test tool is not covering this specific >>> case. They where only tested on a real world setup. >>> >>> Patch 5-8 optimizes all modifying operations by splitting the locks >>> for insert and deletions per zone. (In v3 this was a single patch) >>> >>> Patches 9-13 optimize connection cleaning. The goal is to have a >>> predictable performance of the conntrack cleaning process independent if >>> there is only a single gigantic zone in use or if there are a lot of >>> small ones. >> >> Here are mailing list links to my replies. For some reason, even though >> there are `Reply-To: Felix Huettner <[email protected]>` >> tags in the mails you sent, they aren't including you properly. I'm not >> actually sure what is causing it, but I'll look into my email client >> settings. > So, I asked an LLM. And it seems to be cause by Felix'es mail client > adding Mail-Followup-To header pointing to the list address. That > tells other clients that all replies should be sent to the list instead > of Felix. > > Felix, if that's an intentional config from your side and you prefer > just receiving replies through the list subscription, that's fine. > No worries. :) But if you're annoyed by people not including you in > Cc/To in their replies, you may want to re-configure your client to not > include that header. > > In case of mutt (an LLM guessed that the client is mutt or derivative) > it would be either changing 'subscribe' to 'lists' for ovs-dev or > 'set followup_to=no'.
Okay - that's exactly it. My mail client even gives me the option to ask or ignore. When I set it to ask, it gives me the following as a warning: You should normally obey the Mail-Followup-To: header. In this article, it has the value of [email protected] which directs your response to that address only. Most commonly, Mail-Followup-To is used by a mailing list poster to express that responses should be sent to just the list, and not the poster as well. If a message is posted to several mailing lists, Mail-Followup-To may also be used to direct the following discussion to one list only, because discussions that are spread over several lists tend to be fragmented and very difficult to follow. Also, some source/announcement lists are not intended for discussion; responses here are directed to other addresses. You may customize the variable `message-use-mail-followup-to', if you want to get rid of this query permanently. And if I want, I can tell it to ignore the header. In general, it actually seems a bit rude to ignore what the poster requested with their configuration, so I'll keep it as obeyed, and continue to not manually add in Felix to replies. > Best regards, Ilya Maximets. > _______________________________________________ > dev mailing list > [email protected] > https://mail.openvswitch.org/mailman/listinfo/ovs-dev _______________________________________________ dev mailing list [email protected] https://mail.openvswitch.org/mailman/listinfo/ovs-dev
