w1d.d dates from 2006, that's a long time ago in linux kernel years. The w1
interface has changed considerably to I don't know if that interface still
works. In particular, there was only support for a small subset of 1wire
slaves (basically temperature sensors for hardware monitoring). The generic
command ability was added later.
Paul Alfille
On Wed, May 16, 2012 at 12:29 PM, Ethan Xue <[email protected]> wrote:
> Hi,
>
> I'm try to use w1d.c from http://www.ioremap.net/archive/w1/. According
> to documation "w1.netlink", this program can "uses read/write/search
> commands for all master/slave devices found on the bus.". I'm using w1-gpio
> as w1 master, and i can see the 64bit chip id though sysfs. After i run
> compiled w1d, it prints nothing.
>
> So, how to use this program? I can't get answer from its source code.
>
> btw, I've compiled "netlink connector" support in my kernel.
>
> Thanks.
>
>
> ------------------------------------------------------------------------------
> Live Security Virtual Conference
> Exclusive live event will cover all the ways today's security and
> threat landscape has changed and how IT managers can respond. Discussions
> will include endpoint security, mobile security and the latest in malware
> threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/
> _______________________________________________
> Owfs-developers mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/owfs-developers
>
>
------------------------------------------------------------------------------
Live Security Virtual Conference
Exclusive live event will cover all the ways today's security and
threat landscape has changed and how IT managers can respond. Discussions
will include endpoint security, mobile security and the latest in malware
threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/
_______________________________________________
Owfs-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/owfs-developers
