On Fri, Jul 15, 2011 at 8:55 PM, Pedro Côrte-Real <[email protected]> wrote: > On Fri, Jul 15, 2011 at 7:55 PM, Paul Alfille <[email protected]> wrote: >> That's great. >> In looking through the code to figure out your difficulty, I found a way to >> optimise the code and reduce wear on the DS2438. It will be reflected in the >> next release. >> Briefly, the VAD/VDD switch is taken from the scratchpad memory, rather than >> EEPROM backup. By only setting the option in the scratch pad, we speed up >> conversion and reduce flashing the eeprom. Even better, each read of the >> voltage pulls the VAD/VDD switch back from eeprom, reducing the work another >> 25%. > > That may end up being needed after all. It seems I spoke too soon. > After a few hours of good reads I started getting bad ones again. > Maybe resetting the hub and sensors was enough to make it work for a > little while. saal's outlier removal might have kicked in again as > well.
I upgraded to 2.8p17 and it seems the issues with the hobby board humidity/temp sensors have gone away. Unfortunately it seems my TAI8570 sensor went beserk with it. I'm using parasitic power with it over a long line so that's probably the issue. I'll be changing it to a clean 5V source to see if that fixes it. Now if I could only find some 6pin RJ11 plugs... :) Pedro ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Owfs-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/owfs-developers
