Am 06.07.2013 17:40, schrieb Peter Hollenbeck:
> I am building a 26 foot wood power boat. The bilge below the cabin and
> afterdeck floor is 7 sealed water tight (hopefully) compartments. I plan no
> inspection ports but would like a way to detect moisture. If there were an
> appropriate sensor I could embed one in each compartment and occasionally
> hook up a Raspberry Pi and check for the presence of water. Cost is a
> consideration.
>
I would check this with two temperature sensors, one where sure is air
and one at the deepest point in the bilge. When the boat leaks, water
will be at the place and the temperature drops below air temperature.
Kind regards
Jan
------------------------------------------------------------------------------
This SF.net email is sponsored by Windows:
Build for Windows Store.
http://p.sf.net/sfu/windows-dev2dev
_______________________________________________
Owfs-developers mailing list
Owfs-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/owfs-developers
