> -----Message d'origine----- > De : Yoshihiro Ohba [mailto:[EMAIL PROTECTED] > Envoyé : samedi 14 avril 2007 06:28 > À : [EMAIL PROTECTED] > Objet : [Pana] Error message processing > > I discussed with Rafa and found some issue on error message > processing. > > The current specification specifies the rule on error message > processing, but it is not clear what is the right protocol > behavior after processing an error message. The erroneous > request/answer transaction will be terminated after a > protected error message exchange. But what is the next > behavior? Repeating the erroneous request/answer transaction > until session times out is obviously not a good approach. I > think that a simple behavior is to silently terminate the > PANA session immediately after any protected error message exchange.
Agreed. I assume that the "silently" is only related to the PANA session termination, because the PANA peer will have to anyway take into account the error notification ;) > > Note that if an error message is non-protected, the following > rule described in Section 5.8 still applies: > > If an error request or answer message is sent unprotected (i.e., > without using an AUTH AVP) then the message MUST be processed such > that the receiver does not change its PANA protocol state. > > Regards, > Yoshihiro Ohba > > > _______________________________________________ > Pana mailing list > [EMAIL PROTECTED] > https://www1.ietf.org/mailman/listinfo/pana > _______________________________________________ Pana mailing list [EMAIL PROTECTED] https://www1.ietf.org/mailman/listinfo/pana
