Hi Utkarsh
Thanks for the answer. I had a look at the wikipage (Adding a new
Representation), but it seemed too complicated for a small issue like this.
-Bryn
Utkarsh Ayachit wrote:
Bryn,
It's not possible to change the default representation. However, it's
possible by wiring a plugin to do the same, would that help?
Utkarsh
On Fri, Feb 6, 2009 at 5:08 AM, Bryn Lloyd <[email protected]> wrote:
Hi,
Is it possible to change the default representation of a given (existing)
data type?
I would like to set the default representation of vtkImageData to slice.
Thanks
Bryn
_______________________________________________
ParaView mailing list
[email protected]
http://www.paraview.org/mailman/listinfo/paraview
--
-------------------------------------------------
Bryn Lloyd
Computer Vision Laboratory
ETH Zürich, Sternwartstrasse 7
CH - 8092 Zürich, Switzerland
Tel: +41 44 63 26668
Fax: +41 44 63 21199
-------------------------------------------------
_______________________________________________
ParaView mailing list
[email protected]
http://www.paraview.org/mailman/listinfo/paraview
