I've come across a strange issue with the Slice filter. Admittedly, I am using an older version of ParaView (3.6.2) but, before I go through the process of getting 3.10 compiled again, I wondered if anyone has also had this problem. Essentially, when I wish to take a slice using a plane source, the bounding box I can move the slice widget within does not capture the entire geometry. However, if I manually click on the slice normal and location in the filter panel it works. Also, using the slice offset values also works fine. Finally, both the sphere and box sources correctly determine the bounds of the data-set. I am testing this out on a new reader I created recently, and I'm wondering if there is something I've missed out? Notably, the bounds of the test geometry I'm reading in for X, Y, and Z dimensions is 0 to 1, but this should really matter.
Has anyone come across this issue before? Regards, Adriano =================================== Adriano Gagliardi MEng PhD Business Sector Leader Computational Aerodynamics Aircraft Research Association Ltd. Manton Lane Bedford Tel: 01234 32 4644 E-mail: agaglia...@ara.co.uk Url: www.ara.co.uk ********************************************************************** This email contains information that is private and confidential and is intended only for the addressee. If you are not the intended recipient please delete it and notify us immediately by e-mailing the sender. Note: All email sent to or from this address may be accessed by someone other than the recipient, for system management and security reasons. Aircraft Research Association Ltd. Registered in England, Registration No 503668 Registered Office: Manton Lane, Bedford MK41 7PF England VAT No GB 196351245 ********************************************************************** _______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Follow this link to subscribe/unsubscribe: http://www.paraview.org/mailman/listinfo/paraview
