It appears that this problem also happens when I put the data on the root
partition. For some reason when ParaView restores the state, wind blade reader
thinks it's being told to load in the "Density" array, and not the "UVW" array
as I specified. I can't seem to load in the UVW array after paraview starts
either...this only happens when trying to restore a state for this data set
(i.e. not when I open the data set without loading a state). This doesn't
happen with other .wind data sets, only this new fairly large one (which is
about 600 MB per time step).
Sohail
________________________________
From: Sohail Shafii <sohailsha...@yahoo.com>
To: "paraview@paraview.org" <paraview@paraview.org>
Sent: Thursday, November 17, 2011 2:52 PM
Subject: Data does not load off of a partition from saved (.wind) state
Hi,
I've noticed that if I open a data set from a separate partition (after
mounting it in Linux), and if I save a state file related to said data set, the
data does not load at all when I load the statefile if after I start ParaView
from a clean state. Please note that it doesn't matter if the state file is
saved on my root partition or on the separate partition. Also, this is specific
to the wind blade reader. I've debugged it and it appears to be reading the
data when loading the saved state...for some reason that information does not
get passed to the ParaView pipeline.
The end result is that I have a Field, Blade and Ground ports except all three
have zero points and cells. This is for the release branch of ParaView.
Any thoughts? Thanks.
Sohail
_______________________________________________
Powered by www.kitware.com
Visit other Kitware open-source projects at
http://www.kitware.com/opensource/opensource.html
Please keep messages on-topic and check the ParaView Wiki at:
http://paraview.org/Wiki/ParaView
Follow this link to subscribe/unsubscribe:
http://www.paraview.org/mailman/listinfo/paraview