Peter:
Please see my reply to Hugh for my
main objective in asking for help. It was getting
the hard drive back to its "box" condition.
Upgrading the BIOS seems to be the direct
way to get the PC and the hard drive compatible
and I will try that. The BIOS failed several years
ago within the PC three year warrantee and
the PC manufacturer replaced it.
That 1054 was not a typo. I read it wrong during
the POST. I checked it again and it was s1854.
The eyes are going before the fingers.
Wally
On Fri, 09 Mar 2007 15:48:44 -0500 Peter Kaulback
<[EMAIL PROTECTED]> writes:
> Wally, you need to upgrade the BIOS, it currently is at 1.07
> http://www.tyan.com/archive/support/html/b_s1854.html for the
> Trinity
> 400. I hope you had a typo in saying it's a 1054.
>
> This is a BIOS limitation and hopefully it is resolved with an
> update,
> if not then do contact Tyan.
>
> Or you may have to partition the drive into smaller pieces, say 5
> partitions.
>
> HTH
>
> Peter Kaulback
>
> [EMAIL PROTECTED] wrote:
> > I need some advice..
> >
> > My son has a Pentium III at 600Mh computer with a
> > Tyan S1054 Trinity 400
> > and an Award Plug and play Bios extension 1.0A
> > 1999 by Award software.
> > with an operating 40 Gb hard drive with Win 98 SE.
> >
> > He purchased a Seagate 160 Gb EID hard drive
> > and attempted to install it using the Seagate install
> > wizard and Seagate tools. He intended to make this
> > drive the master boot drive with a new operating
> > system. The other drive would be formatted and
> > become a slave.
> >
> > After running the Seagate Wizard and Seagate
> > tools the drive now is a 32 Gb drive and there seams to
> > be no way to change it using the Seagate Wizard
> > or tools.
> >
> > The seagate help desk says that the problem is the
> > limitation of the computer bios and if we want to
> > use the drive in an other computer at its full
> > capacity, we need to do a Low Level format.
> > This involves filling the disk with zero's.
> >
> > The Seagate tools changed the size value that
> > the bios sees for the drive. Why can't that
> > value be changed to the true size of the drive?
> >
> > What can be done to get this drive back to
> > its "new" condition?
> >
> > Wally
============= PCWorks Mailing List =================
Don't see your post? Check our posting guidelines &
make sure you've followed proper posting procedures,
http://pcworkers.com/rules.htm
Contact list owner <[EMAIL PROTECTED]>
Unsubscribing and other changes: http://pcworkers.com
=====================================================