> Date: Fri, 9 Nov 2012 17:25:41 +0100 > From: zmoel...@iem.at > To: pd-list@iem.at > Subject: Re: [PD] bi-directional OSC over TCP from liblo > > On 11/09/2012 05:14 PM, martin.pe...@sympatico.ca wrote: > > If you look inside [unpackOSCstream] you'll see that it uses [slipdec]. > > So the other end must be using [slipenc] or they won't match up. > > Unless you are doing this over a serial connection there is no need to > > use SLIP at all. [unpackOSC] should work properly with [tcpclient] or > > [tcpserver]. > > > > but TCP/IP *is* a serial connection (that is: stream-based rather than > packet-based). > if you are sending OSC-data over TCP/IP without using SLIP, you are > violating the OSC1.1 standard. > Ah yes. I was mixed up with the original use of slip: to pack entire tcp/ip packets, not just the payload, for transmission over a byte-oriented serial link. Martin
_______________________________________________ Pd-list@iem.at mailing list UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list