Hi
I am reading in a series of PDL's using rcols representing co-ordinates
of hole positions from a CMM. My problem is that the measurement device
does not recognize every hole so that there are gaps in the first PDL
that contains the number of each hole, so instead of
0,1,2,3,4,5,6,7....................... I get
0,1,2,4,6,7..................... or similar. Is there a way to fill in
the missing elements as a PDL or do I need to convert back to a Perl
list. Once I have the filled first PDL I would then like to convert the
other PDL's from the same file to put in BAD values in the corresponding
positions. Hopefully this will allow me to compare two files where the
device has recognized a different number of holes from what should be
the same pattern.
--
Erik
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
pdl-general mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/pdl-general
