Thanks for posting these. I wonder if the prime holds up any better.

On Thu, Aug 14, 2014 at 8:36 PM, Mark C <pdml-m...@charter.net> wrote:
> I ordered a set of the Opteka tubes for the Q last week and they arrived
> today.
>
> First impressions: They work as advertised retaining full AF and aperture
> control etc. They have full contacts so everything functions as you'd
> expect. But - the AF gets somewhat unreliable at higher magnifications.
> Build quality seems to be good.
>
> The only issue I note is that 10, 16 and 21mm tubes are quite long for the
> focal lengths and small sensor size. With the 10mm tube the 8.5mm is already
> over 1:1 lifesized. Given the sensor size, lifesized = a subject frame with
> a 6-7mm diagonal.
>
> The shorter tubes seem to work very well on the 15-45 f2.8 tele zoom and it
> retains usable AF as well. Some quick grab shots of a dime using the 10mm
> and 16mm tube and that lens. These are uncropped frames and as close as I
> could get to maximum magnification. Working room was about 8 inches from the
> front of the lens for the first shot and about  5 inches for the 2nd.  Flash
> was done using a DIY diffuser on the built in flash (the design that Tione
> shared some time ago.)
>
> http://www.markcassino.com/b2evolution/index.php?blog=9
>
> I hope to run this setup through its paces in the next week or so.
>
> I also picked up a Case Logic DCB 304 for the Q kit for about $10. Finally
> the right size bag - comfortably holds the Q, batteries, cards, 4 lenses,
> tubes and other bits and bobs - just big enough but still dang small...
>
> Mark
>
> ---
> This email is free from viruses and malware because avast! Antivirus
> protection is active.
> http://www.avast.com
>
>
> --
> PDML Pentax-Discuss Mail List
> PDML@pdml.net
> http://pdml.net/mailman/listinfo/pdml_pdml.net
> to UNSUBSCRIBE from the PDML, please visit the link directly above and
> follow the directions.

-- 
PDML Pentax-Discuss Mail List
PDML@pdml.net
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow 
the directions.

Reply via email to