Well, I looked and I see a way to read in DNG raw files and process them, but not output DNG files again. I don't see the option to flip them either.
G On Sep 21, 2014, at 5:29 PM, Zos Xavius <[email protected]> wrote: > Yeah, there is a way. If it saves you some time I will look at my copy > of vuescan at work tomorrow. You can have it run through scan files > and apply corrections/changes to them. > > On Sun, Sep 21, 2014 at 3:43 PM, John <[email protected]> wrote: >> Vuescan has the option to "mirror", but I think it only works while >> scanning. I didn't find any option to open an image in Vuescan after it's >> been scanned. >> >> If I had noticed it while I was scanning, I could have used that "mirror" >> option - but given the scanner I'm using, it would have been just as easy to >> pop the slide out & reinsert it correctly. >> >> What I've done to help myself in the future is made some notes to tell me >> which way to insert the slides in the scanner so I don't screw it up next >> time. I taped the note to the wall right over my computer monitor so I can't >> miss it when I'm scanning. >> >> Negatives don't have that problem, because I just have to insert it so the >> pre-print on the film is right side up & readable. That also works with >> slide film where I had them cut it into strips & sleeve it instead of >> getting the slides mounted. >> >> Looks like I'm just going to have to re-scan that one batch and this time >> insert the slides the right way around. >> >> Thanks for all the suggestions though. -- PDML Pentax-Discuss Mail List [email protected] http://pdml.net/mailman/listinfo/pdml_pdml.net to UNSUBSCRIBE from the PDML, please visit the link directly above and follow the directions.
