As long as you had fun!

Alan C

-----Original Message----- From: Stanley Halpin
Sent: Thursday, August 27, 2015 4:14 PM
To: Pentax-Discuss Mail List
Subject: Lessons from the field

In case any of you were wondering:

1. If you are using a Wansen-brand cheap radio wireless flash controller, you may find that it works better when the sending unit on the camera and the receiving unit on the flash are both set to the same channel.

2. More seriously, you may also find that this setup is a bit unreliable even when channel synchronicity has been achieved, but reliability/consistency seems to improve if you trigger a Test flash via the sending unit each time you power up the flash. This may save you several trips through the surf out to the rock where you have your flash balanced so as to light up the foreground boulder, as you fiddle with connections etc.

3. If you drop your AF540 FGZ II in the lake and it lands on a partially covered rock and the battery door pops open and the batteries fall out and water fills the battery compartment, and if you then leave the flash with battery door open, on the shelf in the motel room for two days, and if you then take said flash home and pack it away, and if you then remember to check it after a few days and install new batteries, then you will find that the flash works just fine. While I don’t recommend following the above procedure, it is comforting to know that the WR claim for this flash apparently has some merit.

Stay tuned next month, same time, same station, as your intrepid field photographer and his close companion Obviousman take on the continuing challenges of photography in the wild…

stan


--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow the directions.

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow 
the directions.

Reply via email to