Dig reports "Transfer failed".
I'm guessing there must be some config issue on DNS1.
How do I turn debugging on?
Augie Schwer wrote:
On Wed, May 21, 2008 at 6:40 AM, Kieran Barnes <[EMAIL PROTECTED]> wrote:
But I am getting the following errors
May 21 14:39:23 adder pdns[28233]: 1 slave domain needs checking
May 21 14:39:23 adder pdns[28233]: No serial for '<any domain>' found - zone
is missing?
May 21 14:39:23 adder pdns[28233]: Unable to AXFR zone '<any domain>':
Remote nameserver unable/unwilling to AXFR with us: RCODE=5
I can't seem to figure out what RCODE=5 means.
http://www.faqs.org/rfcs/rfc1035.html ; that's the technical
definition, which basically says what you see "action refused".
Any suggestions?
Did you check that you can manually transfer zones?
dig -t axfr domain @dns1
--
Kieran Barnes
_______________________________________________
Pdns-users mailing list
[email protected]
http://mailman.powerdns.com/mailman/listinfo/pdns-users
