Hi Gang,
Just wondering if possibly something is maybe wrong with my P99SE
install.
I never normally used the Acute Angle DRC check but decided to try it
on one of my boards this morning. It is flawed in it's basic operation. It is
reporting all sorts of 135 degree corners as being 45 degrees. A regular route
with a 45 degree chamfer should actually be measured as 135 degrees for the
purposes of an acute angle check, P99SE says it is a 45 degree angle and
violates the 90 degree Acute Angle rule. It is not 45 degrees to anything, it
is either 135 degrees or 225 degrees no matter how you measure it. Do you mean
to tell me that P99SE programmers couldn't even get this right?
Can others confirm this is normal for 99SE? Has this been fixed in DXP
for any of you out there using DXP? I know that I haven't noticed it being
mentioned before and I guess I probably knew this at some point previously,
that is why I never used it even though it could be useful for double checking
my work.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
