Re: [PEDA]Easy way to make a Plated Slot?

[Brian Guralnick]

   Yes, reserve mechanical layer 4 for all slots & cuts, using a simple 
trace & it's diameter for the slot size.  Put the description in the fab 
docs that you are using mechanical layer 4 as a slot description layer. 
This way, you can create footprints with slots on mech layer 4 & it's easy 
to add a clearance rule for the layer.


----- Original Message ----- 
From: "Harry Selfridge" <[EMAIL PROTECTED]>
To: "Protel EDA Discussion List" <PEDA@techservinc.com>
Sent: Wednesday, May 18, 2005 10:42 PM
Subject: Re: [PEDA]Easy way to make a Plated Slot?


Nope....nothing easier than describing it with a fab note.
At 05:08 PM 5/18/2005, you wrote:
Is there an easy way to make a plated square slot in 99se other then
defining one in a fab drawing?
Thanks,
J.
snip
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:PEDA@techservinc.com
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/proteledaforum@techservinc.com
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/peda@techservinc.com 

____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:PEDA@techservinc.com
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/proteledaforum@techservinc.com
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/peda@techservinc.com