I concur. Have done slots this way for nearly a decade with ZERO problems.
>-----Original Message----- >From: [EMAIL PROTECTED] >[mailto:[EMAIL PROTECTED] On Behalf Of Brian Guralnick >Sent: Thursday, May 19, 2005 11:34 AM >To: Protel EDA Discussion List >Subject: Re: [PEDA]Easy way to make a Plated Slot? > > Yes, reserve mechanical layer 4 for all slots & cuts, >using a simple trace & it's diameter for the slot size. Put >the description in the fab docs that you are using mechanical >layer 4 as a slot description layer. >This way, you can create footprints with slots on mech layer 4 >& it's easy to add a clearance rule for the layer. > > > >----- Original Message ----- >From: "Harry Selfridge" <[EMAIL PROTECTED]> >To: "Protel EDA Discussion List" <[email protected]> >Sent: Wednesday, May 18, 2005 10:42 PM >Subject: Re: [PEDA]Easy way to make a Plated Slot? > > >> Nope....nothing easier than describing it with a fab note. >> >> At 05:08 PM 5/18/2005, you wrote: >>>Is there an easy way to make a plated square slot in 99se other then >>>defining one in a fab drawing? >>> >>>Thanks, >>>J. >> snip >> >> >> ____________________________________________________________ >> You are subscribed to the PEDA discussion forum >> >> To Post messages: >> mailto:[email protected] >> >> Unsubscribe and Other Options: >> http://techservinc.com/mailman/listinfo/peda_techservinc.com >> >> Browse or Search Old Archives (2001-2004): >> http://www.mail-archive.com/[email protected] >> >> Browse or Search Current Archives (2004-Current): >> http://www.mail-archive.com/[email protected] > > > >____________________________________________________________ >You are subscribed to the PEDA discussion forum > >To Post messages: >mailto:[email protected] > >Unsubscribe and Other Options: >http://techservinc.com/mailman/listinfo/peda_techservinc.com > >Browse or Search Old Archives (2001-2004): >http://www.mail-archive.com/[email protected] > >Browse or Search Current Archives (2004-Current): >http://www.mail-archive.com/[email protected] > > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
