Thanks Steve,
"not the more obvious left column"
That is what was getting me. :)
Thanks
Jason
[EMAIL PROTECTED] wrote:
In a message dated 2005-06-27 02:21:31 PM Eastern Daylight Time,
[EMAIL PROTECTED] writes:
When I try to do the global function it only finds the one
100nF and doesn't update the part fields.
Make sure of course that you're searching on the Part Type field, and that
they are in fact all spelled the same, and that you're writing the new value
over in the far right column, not the more obvious left column. The names could
be quite different unless the same guy entered them all; personally I would
write the Type field as 0.1µF, but there are also those who would write 0.1uF
(note the subtle but important difference, for a text match), or even .1µF or
.1uF (yech!!).
Steve Hendrix
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
--
~~~~~~~~~~~~~~~~~~~~~
Jason Van Dellen, C.E.T.
Trilogy-Net Inc.
#4; 1935 - 27Ave NE
Calgary, AB
T2E 7E4
http://www.trilogy-net.com
Phone (403) 219-8868
Fax (403) 219-8860
Cell (403) 815-1626
Email address:
[EMAIL PROTECTED]
~~~~~~~~~~~~~~~~~~~~~
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
