It's not necessary, but if you don't use one, you are setting yourself up for mistakes and possible ridicule. Using a netlist will guide you when routing and allow you to check your work against a schematic.
I would highly recommend using a netlist. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of tastingfan tastingfan Sent: Wednesday, July 20, 2005 8:19 PM To: [email protected] Subject: [PEDA] Is a netlist necessary? Hi, In Protel2004 a netlist can be created under Design->Netlist for Project->Protel. Is it necessary for the following PCB design? Best Regards Tasting_fan --------------------------------- DO YOU YAHOO!? 雅虎免费G邮箱－No.1的防毒防垃圾超大邮箱 ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected] ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
