What sort of FET are you using? A part number for example, would be helpful
> -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > On Behalf Of tastingfan tastingfan > Sent: Thursday, 11 August 2005 2:10 PM > To: [email protected] > Subject: [PEDA] simulation of an Open Drain > > > Hi, > > > > I want to simulate an Open Drain circuit (N channel). The parameters are > following > > > > 1, Gate: input (impulses): 0-3.3V > > 2, Drain connected with a pull-up of 4.7K to 5V > > 3, Source connected with GND. > > > > But the output range is 4.891–5V, not 0V-5V. Why? > > > > Best Regards > > Tasting_fan > > > > --------------------------------- > DO YOU YAHOO!? > 雅虎免费G邮箱－中国第一绝无垃圾邮件骚扰超大邮箱 > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
