just make the holes smaller (24mils)
easy to do w/ globals
ds
_______________________________________________________________________
Integrated Controls, Inc. Tel: 415-647-0480 EXT 107
2851 21st Street Fax: 415-647-3003
San Francisco, CA 94110 www.integratedcontrolsinc.com
Brad Kosiance wrote:
I converted a two layer PBC to a 4 layer PCB.
The vias are 28/40 mils.
The PCB manufacturer is okay with 6 mil annular ring on the top and bottom
layers but requires 8 mil on the internal layers.
Must the vias be replaced with pads to achieve this? If so can all the vias
be replaced with pads globally or do they have to be replaced manually?
Protel 99SE.
Thanks,
Brad.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
