Hi Brian,
Friday night rush hey?
Here you go.
In your match by column for the net name you would put - input_chA*
In your copy attributes column you would place - (input_chA=input_chB)
Special note: Then as well, you have to manually change the netname field in
the initial part you are doing this global edit in, the changes won't occur to
the part you are actually editing, except if you do it manually while you have
it open or after you have changed all the others globally.
If you want to do this over several sheets set the scope at the bottom
of the global edit window for all open schematic sheets.
Have a good weekend, don't waste all of Friday night on work.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2232 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Brian Guralnick [mailto:[EMAIL PROTECTED]
Sent: Friday, June 23, 2006 4:54 PM
To: Protel EDA Discussion List
Subject: [PEDA] P99SE Schematic net renaming...
It's been awhile since I had to do this & I forgot how.
I have a bunch of net name 'input_chA_0'. Nothe that the 0 is the net
numbers going from 0 up to 127.
Using the wild card & copy attributes boxes, how can I change the
'input_chA_0' to 'input_chB_0' for all the net #s leaving them intact for
the rest of the schematic?
Thx in advance...
____________
Brian G.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
