I would suspect a hardware or software problem now. Hardware problem such as bad RAM or over heating (dirty fans, underpowred PSU), marginal or failing component, etc.
Software problems could include corrupted Windows installation, software conflict (as someone else mentioned, anti-virus software could do this), bad/incorrect hardware drivers, etc. To start, I would recommend running Windows Memory Diagnostic or Memtest86. Then run the Prime95 torture test. This would at least give you an idea of your hardware stability. (All free programs, you can locate them via Google) --- Dusan Mihajlovic <[EMAIL PROTECTED]> wrote: > I have tryied clean uninstall proposed from Protel > but with no success. > After I reinstalled Protel 99se SP6 it worked fine > for a while, then when > tryed opening some of pcb designs it reported the > same error message like > before: > > "Format '%x' invalid or incompatible with argument." > > After 10 attempts (opening and closing design) i > managed to open it without > errors. > > It's strange to me that on the slower machines it > runs perfectrly! __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
