In addition to this, as I work at a manufacturer, I'm sure we'd be more than happy to do a check-plot of the artwork onto film for the customer to check the outputs prior to manufacture.
Far cheaper than 'suck it and see' board runs. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dan Enslen Sent: Wednesday, 29 November 2006 6:58 AM To: 'Protel EDA Discussion List' Subject: Re: [PEDA] Octagonal Pads Good Afternoon All, I am not in the same position here as most, and I have absolutely no experience with Gerber readers, but it seems to me that it would be quite easy these days to make a prototype run to check out any radically new or questionable PCB structures. Granted, the monetary resources may prohibit this in a lot of cases. Just my 2 cents worth. Dan Enslen The only reason time exists is so everything doesn't happen all at once. ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
