Hi, Check with your pcb manufacturer. Mine suggested to put a line of required length and width on the mechanical layer, to which they route it out, thus creating an almost rectangular hole.
Kind regards Peter -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of tastingfan tastingfan Sent: Thursday, 4 January 2007 5:46 PM To: [email protected] Subject: [PEDA] rectangular through holes Hi, why can’t I change the form of through holes into rectangular with Protel 2004? I tried some times but only got round ones! Thanks __________________________________________________ 赶快注册雅虎超大容量免费邮箱? http://cn.mail.yahoo.com ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected] ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
