Guys,
I don't understand where your scaling issues are coming from. I have
always found that with SP6 the package doesn't even suggest scaling unless the
import is not fitting into the positive quadrant work space. Therefore I would
say that your problem is more likely either that something is spilling out of
the positive quadrant work area or typically it could also be an issue with
units. Particularly when someone gets an imperial/metric mix happening between
Protel and their import.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2232 ext. 225
fax (250) 762-3374
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
Sent: Monday, February 19, 2007 7:31 AM
To: Protel EDA Discussion List
Subject: Re: [PEDA] DXF import size limitation
I do use SP6, I typo'd too. oops.
SP4 has the problem with wanting to rescale a DXF, SP6 fixes it, at least for
me. But it seems John still has a problem?
With Kind Regards
Norman Webster
Electronics/Software Engineer
Research & Development
Draeger Safety UK Ltd.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
