Thanks!
On Tue, Jul 19, 2011 at 4:42 PM, Stuart Henderson <[email protected]>wrote:
> On 2011/07/19 06:49, Ben Harper wrote:
> > Hi,
> > I'm trying to NAT out to two DSL modems.
> > I have three network cards on three subnets:
> > re0: 192.168.4.0/24 Internal
> > re1: 41.134.100.222/29 DSL_A
> > re2: 10.10.10.5/24 DSL_B
> >
> > I can NAT out to either re1 or re2, but I have to make my default
> > gateway point to the relevant gateway on that network.
> > How can I tell the route tables or the nat-to command what the gateway
> > machine is?
> >
> > So I can do this, but ***only if my default gateway is
> > 41.134.100.217*** (which is the gateway for that net):
> > pass out on re1 proto tcp from 192.168.4.0/24 to any nat-to re1
> >
> > Likewise, I can do this, but once again, ***only if my default gateway
> > is 10.10.10.1*** (which is the gateway for that net):
> > pass out on re2 proto tcp from 192.168.4.0/24 to any nat-to re2
> >
> > I believe I should be able to make this work without ANY default
> > gateway. But then where do I tell the system
> > what these two gateway machines are?
>
> You need *A* default gateway, but it doesn't matter which you choose.
> Then use "route-to {41.134.100.217@re1, 10.10.10.1@re2}" to redirect
> traffic and nat-to rules for outbound traffic on the relevant interfaces.
> You also need similar tricks with reply-to if you want to accept
> incoming traffic and make sure replies go out the correct interface.
>
>
