On 04/12/2015 08:25 AM, Ilya Ashchepkov wrote:
On Sun, 12 Apr 2015 08:10:48 -0700
Adrian Klaver <adrian.kla...@aklaver.com> wrote:
On 04/12/2015 07:47 AM, Ilya Ashchepkov wrote:
Hello.
I'm setting up hot standby slave.
It recovers from wal archive files, but I can't connect to it:
$ psql
psql: FATAL: the database system is starting up
On master:
# select name,setting from pg_settings where name like 'wal_level';
name | setting
-----------+-------------
wal_level | hot_standby
My slave recovery.conf:
$ cat recovery.conf
# Note that recovery.conf must be in $PGDATA directory.
# It should NOT be located in the same directory as postgresql.conf
# Specifies whether to start the server as a standby. In streaming
replication, # this parameter must to be set to on.
standby_mode = 'on'
# Specifies a connection string which is used for the standby
server to connect # with the primary.
primary_conninfo = 'host=192.168.0.101 port=5432
user=replication password=*'
# Specifies a trigger file whose presence should cause streaming
replication to # end (i.e., failover).
trigger_file = '/media/psqlbak/101/main/standup'
# Specifies a command to load archive segments from the WAL
archive. If # wal_keep_segments is a high enough number to retain
the WAL segments # required for the standby server, this may not be
necessary. But # a large workload can cause segments to be recycled
before the standby # is fully synchronized, requiring you to start
again from a new base backup. restore_command =
'/usr/lib/postgresql/9.3/bin/pg_standby
-t /tmp/pgsql.trigger.5432 /media/psqlbak/101/wals/main/ %f %p %r'
I tried to comment 'restore_command' in recovery.conf on slave,
then slave connects to master and starts receiving data, but I
think it's not very good way. What should I change to receive data
through connection and reach consistent state on slave?
What have you set for hot_standby on the standby server?:
http://www.postgresql.org/docs/9.3/interactive/runtime-config-replication.html#RUNTIME-CONFIG-REPLICATION-STANDBY
Oh! I missed this! Thank you!
Now slave reached consistent state some time after start, but still no
connection to master server and still restoring wal-files.
Not quite sure what you are getting at.
You are not seeing the streaming connection happening?
If a connection is not being made:
1) Dose user replication have REPLICATION rights?
2) Is the pg_hba.conf on the master set up to allow a connection from
the standby for user replication and database replication?
Where are the WAL files coming from?
--
Adrian Klaver
adrian.kla...@aklaver.com
--
Sent via pgsql-general mailing list (pgsql-general@postgresql.org)
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-general
