Thanks, that worked!
----
Aaron Burghardt
[EMAIL PROTECTED]
On Jun 26, 2004, at 4:01 PM, Keary Suska wrote:
on 6/26/04 11:21 AM, [EMAIL PROTECTED] purportedly said:
I attempted to compile 7.4.3 with enable-thread-safety but it fails
and
says it's not supported. My configure command was:
./configure --enable-thread-safety
This is what I did for 10.3.4/7.4.2:
1. Enabled thread support in the platform template:
src/template/darwin (see
src/tools/thread/README for info)
2. Configured/compiled
3. Ran the thread_test program that was created by compile (in
src/tools/thread)
4. Followed any recommendations output by the program
5. Re-configured/compiled
Everything was fine.
Keary Suska
Esoteritech, Inc.
"Leveraging Open Source for a better Internet"
---------------------------(end of
broadcast)---------------------------
TIP 5: Have you checked our extensive FAQ?
http://www.postgresql.org/docs/faqs/FAQ.html
---------------------------(end of broadcast)---------------------------
TIP 1: subscribe and unsubscribe commands go to [EMAIL PROTECTED]