On Fri, Jan 18, 2013 at 3:05 AM, Fujii Masao <masao.fu...@gmail.com> wrote:
> I encountered the problem that the timeline switch is not performed > expectedly. > I set up one master, one standby and one cascade standby. All the servers > share the archive directory. restore_command is specified in the > recovery.conf > in those two standbys. > > I shut down the master, and then promoted the standby. In this case, the > cascade standby should switch to new timeline and replication should be > successfully restarted. But the timeline was never changed, and the > following > log messages were kept outputting. > > sby2 LOG: restarted WAL streaming at 0/3000000 on timeline 1 > sby2 LOG: replication terminated by primary server > sby2 DETAIL: End of WAL reached on timeline 1 > sby2 LOG: restarted WAL streaming at 0/3000000 on timeline 1 > sby2 LOG: replication terminated by primary server > sby2 DETAIL: End of WAL reached on timeline 1 > sby2 LOG: restarted WAL streaming at 0/3000000 on timeline 1 > sby2 LOG: replication terminated by primary server > sby2 DETAIL: End of WAL reached on timeline 1 > I am seeing similar issues with master at 88228e6. This is easily reproducible by setting up 2 slaves under a master, then kill the master. Promote slave 1 and reconnect slave 2 to slave 1, then you will notice that the timeline jump is not done. I don't know if Masao tried to put in sync the slave that reconnects to the promoted slave, but in this case slave2 stucks in "potential" state". That is due to timeline that has not changed on slave2 but better to let you know... The replication delays are still here. -- Michael Paquier http://michael.otacoo.com
