On Fri, Nov 29, 2013 at 06:01:01PM -0500, Jeffrey Walton wrote:
> I know of no other ways to check the result of OpenSSL's chain
> validation. The open question (for me) is where are
> SSL_get_verify_result/X509_V_OK checked? Neither show up in the
> Postgres sources.

According to SSL_set_verify manpage, you are perhaps talking about
SSL_VERIFY_NONE case?  Which has suggestion that you should call
SSL_get_verify_result if you want to know if cert was valid.

But if SSL_VERIFY_PEER is used, this is not needed.

> > 3) libpq starts using TLSv1_2_method() by default.
> > 4) libpq will give switch to users to request TLSv1.2.
> This might have negative effects on non-TLSv1.2 clients. For example,
> an Android 2.3 device can only do TLSv1.0 (IIRC). I think there's a
> similar limitation on a lot of Windows XP clients (depending on the IE
> version and SChannel version). And OpenSSL-based clients prior to
> 1.0.0h (released 14 Mar 2012) will have trouble (if I am reading the
> change log correctly).

Note we are talking about client-side settings here.  So the negative
effect would be that clients with TLSv1.2+ libpq cannot connect to
old servers.

> I believe the "standard" way of achieving TLS1.0 and above is to use
> the SSLv23_client_method() and then remove the SSL protocols with
> SSL_OP_NO_SSLv2 and SSL_OP_NO_SSLv3. I have to use handwaiving around
> "standard" because I don't believe its documented anywhere (one of the
> devs told me its the standard way to do it.).

Indeed - Python ssl module seems to achieve TLSv1.1 and it uses
SSLv23_method().  But still no TLSv1.2.

I'll play with it a bit to see whether it can have any negative effects.

-- 
marko



-- 
Sent via pgsql-hackers mailing list (pgsql-hackers@postgresql.org)
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-hackers

Reply via email to