Another good oil is Zoom-Spout. You can get that at any good auto parts or
hardware store. It has a spout that is flexible and extends to get into those
hard to reach areas.
Harvey Kravitz
On Thursday, October 23, 2014 4:12 PM, Antique Phonograph List
<phono-l@oldcrank.org> wrote:
I also use oil with PTFE (Teflon) added for most of my phonograph oiling
needs. I use the "Slick 50" brand of motor oil and mix it with standard 20
weight motor oil, maybe a 1 to 1 mixture or so. Slick 50 is one of the
first of the PTFE lubricants and is still available from most auto parts
stores. Here's their website:
http://www.slick50.com/
This mixture is especially good for the sliding surfaces such as those
commonly found on Edison machines. The PTFE does what it says it does and
penetrates the pores of the metal to provide continued lubrication that
lasts much longer than ordinary lubricants. So even when the surfaces seem
to look dry, they are still lubricated. I find that it works better than
grease for many applications.
Greg Bogantz
----- Original Message -----
From: "Antique Phonograph List" <phono-l@oldcrank.org>
To: <phono-l@oldcrank.org>
Sent: Thursday, October 23, 2014 5:37 PM
Subject: Re: [Phono-L] Edison cylinder player, a smooth ride for the
carriage?
>I polish the carriage rod in an electric drill using metal polish and an
>old t-shirt. I polish the inside of the carriage that rides on the rod
>with a Q-Tip in a Dremel after cleaning it. Normally the rail and the
>carriage are polished by each other, but keep them oiled. The best oil I
>found was a synthetic oil with Teflon, but they do not make it anymore.
>
> On the motor you can polish all the pivots, the less restriction the
> better.
>
>> Date: Thu, 23 Oct 2014 16:47:50 -0400
>> To: phono-l@oldcrank.org
>> From: phono-l@oldcrank.org
>> Subject: [Phono-L] Edison cylinder player, a smooth ride for the
>> carriage?
>>
>> I could use some suggestions on how to make sure the carriage of an
>> Edison Standard or Gem rides along very smoothly. The back rides on
>> (encircles) the rod near the feed screw, and the front rides on the bar
>> just under the reproducer. (sorry, not sure of the official names) Should
>> those surfaces be polished? Oiled? Smoothed with steel wool? Otherwise
>> made smooth? I finally got my 2 machines (said Standard and Gem) working
>> so they each play through a 2 minute cylinder. But if I use my finger to
>> gently urge the front of the carriage along, it feels (and sounds) as if
>> the motor picks up a bit and works more easily. Certainly, if the drag in
>> those 2 spots is reduced, then the motor wouldn't have to work so hard.
>> So, any thoughts?
>>
>> David Barnett da...@fairlibertyscall.com
>> C: 516-398-8668 www.FairLibertysCall.com
>>
>> _______________________________________________
>> Phono-L mailing list
>> http://phono-l.org
>
> _______________________________________________
> Phono-L mailing list
> http://phono-l.org
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_______________________________________________
Phono-L mailing list
http://phono-l.org
_______________________________________________
Phono-L mailing list
http://phono-l.org
