Author: glen Date: Fri May 31 01:26:01 2013 New Revision: 12687 Modified: rc-scripts/trunk/rc.d/rc.sysinit Log: use sysctl -q instead of /dev/null redirections
Modified: rc-scripts/trunk/rc.d/rc.sysinit ============================================================================== --- rc-scripts/trunk/rc.d/rc.sysinit (original) +++ rc-scripts/trunk/rc.d/rc.sysinit Fri May 31 01:26:01 2013 @@ -364,7 +364,7 @@ fi # Early sysctls - sysctl -e -p /etc/sysctl.conf > /dev/null 2>&1 + sysctl -q -e -p /etc/sysctl.conf # sysfs is also needed before any other things (under kernel > 2.5) if ! is_fsmounted sysfs /sys; then @@ -439,7 +439,7 @@ /sbin/start_udev use_upstart && [ -x /sbin/initctl ] && /sbin/initctl -q start udev elif [ -x /lib/firmware/firmware-loader.sh ]; then - /sbin/sysctl -e -w kernel.hotplug=/lib/firmware/firmware-loader.sh > /dev/null 2>&1 + /sbin/sysctl -q -e -w kernel.hotplug=/lib/firmware/firmware-loader.sh fi # Unmount the initrd, if necessary @@ -456,7 +456,7 @@ # Configure Linux kernel (initial configuration, some required modules still # may be missing). - sysctl -e -p /etc/sysctl.conf > /dev/null 2>&1 + sysctl -q -e -p /etc/sysctl.conf # Check if timezone definition is available if [ -e /etc/localtime ] && [ -e /dev/rtc -o -e /dev/rtc0 ] ; then @@ -688,11 +688,11 @@ if [ -f /proc/sys/kernel/modprobe ]; then if [ -n "$USEMODULES" ]; then - sysctl -w kernel.modprobe="/sbin/modprobe" >/dev/null 2>&1 + sysctl -q -w kernel.modprobe="/sbin/modprobe" else # We used to set this to NULL, but that causes # 'failed to exec' messages" - sysctl -w kernel.modprobe="/bin/true" >/dev/null 2>&1 + sysctl -q -w kernel.modprobe="/bin/true" fi fi @@ -919,11 +919,11 @@ if [ -n "$PANIC_REBOOT_TIME" -a "$PANIC_REBOOT_TIME" -gt "0" -a -f /proc/sys/kernel/panic ]; then show 'Setting %s seconds for kernel reboot after panic' "$PANIC_REBOOT_TIME"; busy # NOTE: you should use /etc/sysctl.conf instead - if sysctl -w kernel.panic=$PANIC_REBOOT_TIME >/dev/null 2>&1; then ok; else fail; fi + if sysctl -q -w kernel.panic=$PANIC_REBOOT_TIME; then ok; else fail; fi fi # ... and here finish configuring parameters - sysctl -e -p /etc/sysctl.conf > /dev/null 2>&1 + sysctl -q -e -p /etc/sysctl.conf else emit --no-wait root-filesystem emit --no-wait virtual-filesystems _______________________________________________ pld-cvs-commit mailing list pld-cvs-commit@lists.pld-linux.org http://lists.pld-linux.org/mailman/listinfo/pld-cvs-commit