DavidBulluss wrote:
> I hope the attached file is the correct one!
>
> David
>
> file:///E:/Downloads%20E/server.log(3).zip33608
The receiver is not responding to a request for the power status of the
Zone 2 amp. Since the plugin does work if the receiver is already turned
on, and powers it off successfully, I would suspect that the receiver is
not set up to stay powered on in standby mode, which is a requirement of
using network control to turn it on. Here are the instructions for
setting this on your AVR:
Code:
--------------------
NETWORK SETUP of AVR-X3000
>Procedure of Network Setup mode.
(1)Press SETUP MENU button, then Menu appears on FL-display (and GUI)
(2)Select Setup Menu > Network > IP Control
(3)Set parameters described below.
Always On---Use this setting when using the AVR-X3000 Connected in a
network.
Off In Standby--- Use this setting when not using the AVR-X3000 connected
in a network.
This setting is reducing the power consumption in the standby mode.
--------------------
I hope this helps.
Sam
------------------------------------------------------------------------
SamY's Profile: http://forums.slimdevices.com/member.php?userid=63495
View this thread: http://forums.slimdevices.com/showthread.php?t=60114
_______________________________________________
plugins mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/plugins
