Hello everyone. pcidump -v:
2:0:0: Intel Wi-Fi 6 AX200 0x0000: Vendor ID: 8086, Product ID: 2723 0x0004: Command: 0006, Status: 0010 0x0008: Class: 02 Network, Subclass: 80 Miscellaneous, Interface: 00, Revision: 1a 0x000c: BIST: 00, Header Type: 00, Latency Timer: 00, Cache Line Size: 10 0x0010: BAR mem 64bit addr: 0x00000000f7c00000/0x00004000 0x0018: BAR empty (00000000) 0x001c: BAR empty (00000000) 0x0020: BAR empty (00000000) 0x0024: BAR empty (00000000) 0x0028: Cardbus CIS: 00000000 0x002c: Subsystem Vendor ID: 8086 Product ID: 0084 0x0030: Expansion ROM Base Address: 00000000 0x0038: 00000000 0x003c: Interrupt Pin: 01 Line: 0a Min Gnt: 00 Max Lat: 00 0x00c8: Capability 0x01: Power Management State: D0 0x00d0: Capability 0x05: Message Signalled Interrupts (MSI) Enabled: no 0x0040: Capability 0x10: PCI Express Link Speed: 5.0 / 5.0 GT/s, Link Width: x1 / x1 0x0100: Enhanced Capability 0x01: Advanced Error Reporting 0x014c: Enhanced Capability 0x18: Latency Tolerance Reporting 0x0154: Enhanced Capability 0x1e: L1 PM 0x0080: Capability 0x11: Extended Message Signalled Interrupts (MSI-X) Enabled: yes; table size 16 (BAR 0:8192) FIRMWARE fw_update -i Installed: inteldrm-firmware-20181218 vmm-firmware-1.11.0p2 iwx-firmware-20191022p0 intel-firmware-20191115p0v0 DMESG iwx0: dumping device error log iwx0: Start Error Log Dump: iwx0: Status: 0x1, count: 6 iwx0: 0x00000071 | NMI_INTERRUPT_UMAC_FATAL iwx0: 002022F0 | trm_hw_status0 iwx0: 00000000 | trm_hw_status1 iwx0: 004FC308 | branchlink2 iwx0: 00016E5A | interruptlink1 iwx0: 00016E5A | interruptlink2 iwx0: 004F9F62 | data1 iwx0: 00001000 | data2 iwx0: F0000008 | data3 iwx0: 00000000 | beacon time iwx0: 00010996 | tsf low iwx0: 00000000 | tsf hi iwx0: 00000000 | time gp1 iwx0: 00010997 | time gp2 iwx0: 00000001 | uCode revision type iwx0: 0000002E | uCode version major iwx0: 177B3E46 | uCode version minor iwx0: 00000340 | hw version iwx0: 18889000 | board version iwx0: 800AFD0C | hcmd iwx0: 00020000 | isr0 iwx0: 00000000 | isr1 iwx0: 18F00002 | isr2 iwx0: 00C0000C | isr3 iwx0: 00000000 | isr4 iwx0: 00000000 | last cmd Id iwx0: 004F9F62 | wait_event iwx0: 00000000 | l2p_control iwx0: 00000020 | l2p_duration iwx0: 00000000 | l2p_mhvalid iwx0: 00000000 | l2p_addr_match iwx0: 00000009 | lmpm_pmg_sel iwx0: 19071335 | timestamp iwx0: 00000828 | flow_handler iwx0: Start UMAC Error Log Dump: iwx0: Status: 0x1, count: 7 iwx0: 0x201010A3 | ADVANCED_SYSASSERT iwx0: 0x00000000 | umac branchlink1 iwx0: 0xC008B1C0 | umac branchlink2 iwx0: 0xC0084E04 | umac interruptlink1 iwx0: 0x00000000 | umac interruptlink2 iwx0: 0x00000002 | umac data1 iwx0: 0x00000001 | umac data2 iwx0: 0xDEADBEEF | umac data3 iwx0: 0x0000002E | umac major iwx0: 0x177B3E46 | umac minor iwx0: 0x00010987 | frame pointer iwx0: 0xC0886C6C | stack pointer iwx0: 0x00050C00 | last host cmd iwx0: 0x00000000 | isr status reg driver status: tx ring 0: qid=0 cur=6 queued=0 tx ring 1: qid=1 cur=0 queued=0 tx ring 2: qid=2 cur=0 queued=0 tx ring 3: qid=3 cur=0 queued=0 tx ring 4: qid=4 cur=0 queued=0 tx ring 5: qid=5 cur=0 queued=0 tx ring 6: qid=6 cur=0 queued=0 tx ring 7: qid=7 cur=0 queued=0 tx ring 8: qid=8 cur=0 queued=0 tx ring 9: qid=9 cur=0 queued=0 tx ring 10: qid=10 cur=0 queued=0 tx ring 11: qid=11 cur=0 queued=0 tx ring 12: qid=12 cur=0 queued=0 tx ring 13: qid=13 cur=0 queued=0 tx ring 14: qid=14 cur=0 queued=0 tx ring 15: qid=15 cur=0 queued=0 tx ring 16: qid=16 cur=0 queued=0 tx ring 17: qid=17 cur=0 queued=0 tx ring 18: qid=18 cur=0 queued=0 tx ring 19: qid=19 cur=0 queued=0 tx ring 20: qid=20 cur=0 queued=0 tx ring 21: qid=21 cur=0 queued=0 tx ring 22: qid=22 cur=0 queued=0 tx ring 23: qid=23 cur=0 queued=0 tx ring 24: qid=24 cur=0 queued=0 tx ring 25: qid=25 cur=0 queued=0 tx ring 26: qid=26 cur=0 queued=0 tx ring 27: qid=27 cur=0 queued=0 tx ring 28: qid=28 cur=0 queued=0 tx ring 29: qid=29 cur=0 queued=0 tx ring 30: qid=30 cur=0 queued=0 rx ring: cur=265 802.11 state INIT iwx0: fatal firmware error iwx0: hw rev 0x340, fw ver 46.393952838.0, address 84:c5:a6:00:10:ef This error appears continuously making the network unusable openbsd# uname -ar OpenBSD openbsd.home 6.7 GENERIC.MP#149 amd64 cat /etc/hostname.iwx0 nwid SetTheControls wpakey mykey dhcp openbsd# ifconfig iwx0 iwx0: flags=808843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,AUTOCONF4> mtu 1500 lladdr 84:c5:a6:00:10:ef index 2 priority 4 llprio 3 groups: wlan egress media: IEEE802.11 autoselect (HT-MCS5 mode 11n) status: active ieee80211: nwid SetTheControls chan 1 bssid 5c:e2:8c:7d:cd:28 56% wpakey wpaprotos wpa2 wpaakms psk wpaciphers ccmp wpagroupcipher ccmp inet 192.168.1.159 netmask 0xffffff00 broadcast 192.168.1.255 I have checked whether on http://firmware.openbsd.org/firmware/ there are other available versions but could not find any. If this can help, on Linux the device works properly with iwlwifi firmware version 48 (it seems from the message below): [giacomo@woody ~]$ dmesg |grep iwl [ 4.737003] iwlwifi 0000:02:00.0: enabling device (0100 -> 0102) [ 4.755949] iwlwifi 0000:02:00.0: Direct firmware load for iwlwifi-cc-a0-50.ucode failed with error -2 [ 4.755969] iwlwifi 0000:02:00.0: Direct firmware load for iwlwifi-cc-a0-49.ucode failed with error -2 [ 4.760181] iwlwifi 0000:02:00.0: TLV_FW_FSEQ_VERSION: FSEQ Version: 43.2.23.17 [ 4.760184] iwlwifi 0000:02:00.0: Found debug destination: EXTERNAL_DRAM [ 4.760186] iwlwifi 0000:02:00.0: Found debug configuration: 0 [ 4.760447] iwlwifi 0000:02:00.0: loaded firmware version 48.4fa0041f.0 op_mode iwlmvm [ 5.178894] iwlwifi 0000:02:00.0: Detected Intel(R) Wi-Fi 6 AX200 160MHz, REV=0x340 [ 5.189989] iwlwifi 0000:02:00.0: Applying debug destination EXTERNAL_DRAM [ 5.190304] iwlwifi 0000:02:00.0: Allocated 0x00400000 bytes for firmware monitor. [ 5.340117] iwlwifi 0000:02:00.0: base HW address: 84:c5:a6:00:10:ef [ 5.357817] iwlwifi 0000:02:00.0 wlp2s0: renamed from wlan0 [ 6.841320] iwlwifi 0000:02:00.0: Applying debug destination EXTERNAL_DRAM [ 6.990576] iwlwifi 0000:02:00.0: FW already configured (0) - re-configuring [ 7.019332] iwlwifi 0000:02:00.0: Applying debug destination EXTERNAL_DRAM [ 7.169081] iwlwifi 0000:02:00.0: FW already configured (0) - re-configuring Thanks -- Giacomo S. http://www.giacomos.it Sincrotrone Trieste S.C.p.A. di interesse nazionale Strada Statale 14 - km 163,5 in AREA Science Park 34149 Basovizza, Trieste ITALY - 040 3758073 328 3237959
