OK, razor still sharp, David is just dull (at least while problem solving and eating lunch at the same time).
This is obiously a vector layer question, not a WMS one... On Fri, Oct 12, 2012 at 1:08 PM, David Fawcett <david.fawc...@gmail.com> wrote: > Occam may need a new blade on this one. > > At least at version 10 and below of ArcMap, you can display a > statewide WMS like this one with no problems. The full extent of this > service covers at least 3 UTM Zones. > > http://geoint.lmic.state.mn.us/cgi-bin/mncomp?request=GetCapabilities&version=1.3.0&Service=WMS& > > David. > > On Fri, Oct 12, 2012 at 11:49 AM, Paul Ramsey <pram...@opengeo.org> wrote: >> On Fri, Oct 12, 2012 at 9:03 AM, Mark Volz <markv...@co.lyon.mn.us> wrote: >>> One potential issue is that technically our county falls under UTM 14 and >>> 15. However, since the majority of the state falls inside of UTM 15, many >>> WMS services are published only for UTM 15. Therefore I don't know if >>> ArcGIS is sending an error "The specified coordinate exceeds the valid >>> coordinate range" due to the fact that the western edge of the county is >>> in UTM 14, and not UTM 15, or if there is another issue that I need to fix. >> >> Occams razor states that you have the answer. The error message is >> very consistent with the situation you are describing. Use a >> projection that is valid for your data extent and things should be >> fine. >> >> P. >> _______________________________________________ >> postgis-users mailing list >> postgis-users@postgis.refractions.net >> http://postgis.refractions.net/mailman/listinfo/postgis-users _______________________________________________ postgis-users mailing list postgis-users@postgis.refractions.net http://postgis.refractions.net/mailman/listinfo/postgis-users