I went to the site, but it seems that 2.6.1 is for OSX. And I couldn't find an updater for 9.x.x i guess that the original will have to do?
Thanks recently, Patrick McCarthy at [EMAIL PROTECTED] enscribed: > try the MacGurus site. > ftp://ftp.macgurus.com/%2Fftp/ > You'll find xlr8 drivers, control panels etc there. > The Mach Speed Control 2.6.1 is probably the first to > try (don't have an XLR8 card but I use the software > with my sonnet just fine)I think XLR8 went out of > business. > Here's a serial #: XLR-LS28-JPDS-CFV2 > good luck! > > --- "Larson, Timothy E." <[EMAIL PROTECTED]> > wrote: >> Hello. This question is probably more about the >> upgrade card than the PCP, but I hope that's OK. >> >> I have a second-hand PCP 210 which has been upgraded >> to a G3 with an XLR8 MACh card. I reformatted the >> drive, not realizing that this card "needed" special >> software, which I don't have the original media for. >> <snip> -- Power Computing is sponsored by <http://lowendmac.com/> and... 123Inkjets.com <http://lowendmac.com/ad/123inkjets.html> Support Low End Mac <http://lowendmac.com/lists/support.html> Power Computing list info: <http://lowendmac.com/power/list.html> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> List archive: <http://www.mail-archive.com/powercomputing%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
