Hello all. I have been using powersaved for quite a while now, and after some initial problems in 2.6.17, it works great now for months. Recently I installed a notebook webcam on my laptop this uses the uhci_hcd module. Now I have a problem suspending the laptop. It hangs on unloading this uhci_hcd module. unloading it by hand (modprobe -r uhci_hcd) also doesn't work. I found that uhci_hcd is required by spca5xx (the webcam module) which is in turn used by two programs: kmix and ekiga. When I stop those two programs, suspend works.
Is there a way to tell powersaved to just kill these two programs before suspending? Is there in general a way to specify a pre-suspend script and/or a post-suspend script? Regards, Bert -- ----------------------------------------------- Bert en Selena www.bertenselena.net ----------------------------------------------- Only two things are infinite: human stupidity and the universe, and I'm not sure about the latter. Albert Einstein -----------------------------------------------
_______________________________________________ powersave-users mailing list [email protected] http://forge.novell.com/mailman/listinfo/powersave-users
