Yes, I have two hosts connected to the switch and you're trying to ping across the switch. even if i dont ping the two hosts, as the it conntects to a controller it starts displaying this msg. the ping works but i think due to the switch's self learning process and not through OpenFlow bcaz in the absense of controller the ping should not work? am i right? I was recieving the same msg with mininet then i refreshed the git clone after which it started working, when i try to ping host in mininet it displays the mac addresses and then displays msg adding entry.
wat logs do you want me to send. 1 more thing i can use enable_learning '0' in switch configuration on openwrt but it doesnt effect any thing, where i think of this statement as disable default learning of the switch. the switch chip installed is 'rtl8366rb'. I have a rb450g and i have ported the latest openwrt and followed pantou but same error. thanks alot, Shabbir. please... On Wed, Feb 6, 2013 at 1:03 PM, Murphy McCauley <[email protected]>wrote: > On Feb 5, 2013, at 11:52 PM, Shabbir Ahmed wrote: > > I am trying to set up openflow, openwrt on tp-link, here i have issue, > if i run pox forwarding.l2_learning with mininet it works fine, but when i > try to use it on tp-link, it gives the following msg, > > > > port of (mac address of tplink switch) unknown --- flooding, > > By itself, this message is not particularly meaningful -- it shows up when > you run under Mininet too. > Please post the rest of the log. > When do you see this (that is, what are you trying to do when this > happens)? > Do you have two hosts connected to the switch and you're trying to ping > across the switch? > What else have you tried? What does and does not work? > Have you tried with the betta branch of POX? > > Also, take a look through the troubleshooting section of the FAQ: > http://tinyurl.com/helppox > > -- Murphy
