Thank you. All OF packets are in the loopback inteface. I watched this capture and there's no changeing of destination IP. I added the action before append of.ofp_action_dl_addr.dst mac (that is the same of old destination, because the host has change its IP but not the mac) and of.ofp_action_output(port=prt) (also this is the same). Maybe I put it in a wrong position
2013/7/23 Murphy McCauley <[email protected]> > I assumed you were trying to look at the packet for which you'd done the > rewriting (which I would not expect to be OpenFlow) to see if it had been > rewritten correctly. > > If you want to look at the flow_mod to make sure it looks correct, the > correct interface to look at depends on your configuration. If you're > using Mininet in a VM and POX in your host environment, it's the virtual > adapter between the VM and host (the default sets this up as eth0). But > perhaps an easier way is to run the openflow.debug POX component, which > will generate a .pcap trace file in the POX directory that you can load > into Wireshark. > > -- Murphy > > On Jul 23, 2013, at 3:20 AM, Silvia Fichera wrote: > > Same situation if I whatch, e.g. h1-eth0, and it is pinging. I have only > UDP, ARP and ICMP. No OF packet. > > > 2013/7/23 Murphy McCauley <[email protected]> > >> What happens if you watch the host's interface instead? If you don't see >> the packets there, it seems like you may have a problem elsewhere... >> >> -- Murphy >> >> On Jul 23, 2013, at 3:08 AM, Silvia Fichera wrote: >> >> I've filtered of packets and I can see it ONLY if I choose "any" >> interface. >> If I'm on a switch (the right switch) interface, I see nothing with that >> filter. Without filter I can see only ARP, ICMP and UDP packets. >> >> >> 2013/7/23 Murphy McCauley <[email protected]> >> >>> A couple tips: >>> >>> Make you sure you're running wireshark on the right interface (e.g., the >>> outgoing interface of the switch or the interface of the destination host). >>> >>> Make sure you are doing the output action AFTER you do the rewrite >>> action. >>> >>> -- Murphy >>> >>> On Jul 23, 2013, at 2:48 AM, Silvia Fichera wrote: >>> >>> >>> Hi all, >>> I added in l3_learning the action of changeing dst IP with >>> >>> action.append.(of.ofp_action_nw_addr.set_dst(IPAddr(new_dstaddr))) >>> >>> where new_dstaddr is the new destination IP. >>> How can I check if the action of changing dstip had success? >>> In wireshark I've checked srcip and dstip of the ipv4 packet but the >>> destination is unchanged... >>> >>> Thanks >>> -- >>> Silvia Fichera >>> >>> >>> >> >> >> -- >> Silvia Fichera >> >> >> > > > -- > Silvia Fichera > > > -- Silvia Fichera
