Thanks Pascal, it works using jpath - for some reason using readjpeg
in jqt requires it.
On 19 Jan 2015, at 23:59, 'Pascal Jasmin' via Programming wrote:
untested, but this may be a file not found error. See if
jpath '~/j/cat.jpg'
returns a valid file path. then:
readjpeg jpath '~/j/cat.jpg'
----- Original Message -----
From: Ryan <[email protected]>
To: [email protected]
Cc:
Sent: Monday, January 19, 2015 12:42 AM
Subject: Re: [Jprogramming] jpegs
It works in jconsole, but not in jqt:
load'jpeg'
readjpeg '~/j/cat.jpg'
Qt cannot read JPEG file
Does anyone know how I can fix this?
thanks,
Ryan
On 15 Jan 2015, at 19:22, bill lam wrote:
It is similar to reading/writing bmp, ie. readjpeg and writejpeg
On Jan 15, 2015 2:31 PM, "Ryan" <[email protected]> wrote:
----------------------------------------------------------------------
For information about J forums see
http://www.jsoftware.com/forums.htm
The information in this e-mail is intended only for the person to whom
it is
addressed. If you believe this e-mail was sent to you in error and the
e-mail
contains patient information, please contact the Partners Compliance
HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you
in error
but does not contain patient information, please contact the sender
and properly
dispose of the e-mail.
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
