Works for me fine on Windows 7. I created a script as described. Opened cmd session. Changed directory to where the script was saved and successfully ran the following command. "C:\Program Files\j602\bin\j.exe" -jprofile script.ijs
Did the same thing with a shortcut, again with no problems. > From: Thomas Costigliola > Sent: Wednesday, 9 June 2010 08:57 > > I get the abnormal termination under Windows 7 in J602. I remember this > behavior beginning when I switched from XP to Windows 7. > > > On Fri, Jun 4, 2010 at 12:42 PM, Devon McCormick wrote: > > > I have no problem with this running J6.02 under Windows XP. > > > > 2010/6/4 bill lam <[email protected]> > > > > > Птн, 04 Июн 2010, Mark Niemiec писал(а): > > > > If I run "j -jprofile script.ijs", where script.ijs consists of > the > > > > single line "2!:55 ] 0", > > > > J terminates abnormally with the application error: > > > > "The instruction at "0x7c915395" referenced memory at > "0x003b000c". > > > > The memory could not be "read". > > > > > > > > This seems to always happen whenever I try to terminate a J > program > > > started this > > > > way; the above example was the smallest example illustrating it. > > > > I presume that this is a bug, but if not, is there a preferred > way of > > > > terminating > > > > a stand-alone J application? > > > > > > > > -- Mark D. Niemiec <[email protected]> > > > > > > It works for me. I use that for years. > > > ---------------------------------------------------------------------- For information about J forums see http://www.jsoftware.com/forums.htm
