Hi Ruochun, A follow-up on this question. Meshes are also not included in the checkpoint file. When the checkpoint file is loaded, meshes should be reloaded. The position and orientation of meshes may be changed in previous simulations. So when the meshes are reloaded, are the translation and rotation of meshes needed to be set manually? Is there a way to save the meshes as well (saying output meshes as .obj file which can be easily reloaded)?
Best, Yi On Thursday, December 16, 2021 at 12:23:34 AM UTC-7 Ruochun Zhang wrote: > Hi Yi, > > Yes. If these entries are not in the checkpoint file, then they will not > be loaded when you read that checkpoint file. You have to manually enter > them each time. The material based model is a new addition and this > behavior seems to be an unfortunate bug. > > Thank you, > Ruochun > > On Wednesday, December 15, 2021 at 3:53:25 PM UTC-6 Yi Zhong wrote: > >> Hi, >> >> I am using the GPU module in Chrono/7.0.0. I noticed that when >> *UseMaterialBasedModel >> *, some simulation parameters such as Young's modulus, and Poisson's >> ratio are not included in the checkpoint file. I would like to make sure >> that I do need to specify these simulation parameters again after I load >> the checkpoint file, right? >> >> Best, >> Yi >> > -- You received this message because you are subscribed to the Google Groups "ProjectChrono" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/projectchrono/82e57253-7538-4045-ba24-867ccb44c4dan%40googlegroups.com.
