Hi Eric， To be honest, I don't know how to install it, I think I installed it in C++ (not fully installed), and then pychrono can use the sensor module. In fact, I am also very confused.I have successfully installed it once so far. I'm so sorry.
Jay 在2023年11月29日星期三 UTC+8 21:09:05<[email protected]> 写道： > Hi Jay, > > I see from messages in the group that you were able to get the sensor > module to work for Pychrono. I am having a similar issue with the module. I > followed all the instructions and I am able to run all the demos except for > the sensor module demos. > > I see the _sensor.pyd file. Through toubleshooting, I was able to get an > error that said either _sensor is missing or one of its dependencies. > > Can you please tell me what you did to get the module to load properly? > > Thanks > Eric > On Wednesday, July 5, 2023 at 11:22:33 AM UTC-5 [email protected] wrote: > >> Hi Jay, >> >> Can you enter a Python environment (type "python" in the anaconda >> environment) and type: "import _sensor" from there? It should give you more >> information on what is going wrong. >> >> Kind regards, >> Thomas >> >> On Wednesday, July 5, 2023 at 6:51:50 AM UTC-5 [email protected] wrote: >> >>> Hi Thomas, >>> I have installed Numpy library in conda environment, and I can run >>> the demo that comes with pychrono, such as the demo in vehicle and robot >>> modules, which can be seen in the screenshot on the right above. >>> However, the problems that will occur in the demo running the *sensor >>> module* are the same as what I sent for the first time, as shown in the >>> screenshot above on the left. >>> I can make sure that I have the Numpy library installed because demos >>> like vehicle use the Numpy library. >>> I'm confused about this，looking forward to your reply. >>> >>> Regards, >>> Jay >>> >>> 在2023年7月4日星期二 UTC+8 02:11:28<[email protected]> 写道： >>> >>>> Hi Jay, >>>> >>>> Did you install NumPy in the conda environment? (NumPy is required for >>>> sensor) If you still encounter the problem, enter a python environment and >>>> import _sensor; please take a screenshot of the error form the python >>>> environment. >>>> >>>> Kind regards, >>>> Thomas >>>> On Saturday, July 1, 2023 at 7:41:24 PM UTC-5 [email protected] wrote: >>>> >>>>> Hello, >>>>> My name is Jay Sun, I have already installed pychrono (installation >>>>> manual: >>>>> https://api.projectchrono.org/development/pychrono_installation.html), >>>>> also successfully run the site - packages \ pychrono \ demos, some of the >>>>> demos, But I reported an error when running the *sensor module*. The >>>>> following is the wrong picture. Could you tell me how to solve it? >>>>> >>>>> Thank you very much! >>>>> >>>>> Regards, >>>>> Jay Sun[image: 5b67689809ad65abe16f6e9001ed249.png][image: >>>>> 23d3123aa62cb0a5406b4b13b85d74f.png] >>>>> >>>> -- You received this message because you are subscribed to the Google Groups "ProjectChrono" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/projectchrono/562c6218-c8e8-46c9-b72c-6ad9531c07a8n%40googlegroups.com.
