On 02:02 PM 2/09/2001 +0000, [EMAIL PROTECTED] said:
>When I select the Relative Values checkbox (and change the Start & Stop
>Values) before sweeping a resistor value, I no-longer get the result for
>each pass displayed as an available waveform! The multiple passes are
>still performed, but there is only a single waveform generated. If I
>uncheck the checkbox and enter absolute values, it is OK!
>Is this a bug, feature, or my misunderstanding?
>
>Thanks,
>Steve
>Posted from Association web site by: Steven Beames
Sounds like a bug - make sure you refer it to Protel - either the support
emails or there is an form to lodge bug reports on their www site.
Ian Wilson
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
