Andrew,
you're not suggesting that the poor individual try to use or
navigate the Protel help system are you? Good luck.
Brad Velander,
Lead PCB Designer,
Norsat International Inc.,
#300 - 4401 Still Creek Dr.,
Burnaby, B.C., V5C 6G9.
Tel. (604) 292-9089 direct
Fax (604) 292-9010
website www.norsat.com
> -----Original Message-----
> From: Andrew J Jenkins [mailto:[EMAIL PROTECTED]]
> Sent: Friday, August 31, 2001 5:57 PM
> To: Protel EDA Forum
> Subject: Re: [PEDA] Process Identifiers
>
>
> On 04:15 PM 8/31/2001 -0700, Brad Velander wrote:
> >Keith,
> > the alternate approach that works is as follows. If
> you just want to
> >look at a few processes.
> >
> >Go to your Down Arrow (Left side main toolbar).
> >Select Customize.
>
>
> Or, alternatively, double-click on the menu bar within either
> the Schematic or PCB applications, just to the right of the
> last entry (Help). This will bring up the same dialog
> customization dialog.
>
> Then follow the steps that Brad outlined.
>
> regards,
>
> aj
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *