Thanks for that bit of confidence Ian,
given a moment of peace I will implement the fix and then give it a
try. Worst case is I try the fix again, right. Least of all, as I stated, I
find the display bug just a little bit of a nuisance at worst.
Brad Velander,
Lead PCB Designer,
Norsat International Inc.,
#300 - 4401 Still Creek Dr.,
Burnaby, B.C., V5C 6G9.
Tel. (604) 292-9089 direct
Fax (604) 292-9010
website www.norsat.com
> -----Original Message-----
> From: Ian Wilson [mailto:[EMAIL PROTECTED]]
> Sent: Monday, September 17, 2001 2:59 PM
> To: Protel EDA Forum
> Subject: Re: [PEDA] Problem Found (Ex: Mechanikal Layers are
> disappearing)
>
>
> On 08:56 AM 17/09/2001 -0700, Brad Velander said:
> >Waldemar,
> > haven't tried to implement the fix yet but wanted
> to make sure I
> >understood the cause. Ian said clicking the default button caused the
> >problem. Are you saying that changing the display order using the
> >promote/demote buttons also causes the problem?
> > If the answer to the above question is positive,
> aaarrgghh! That
> >means that we cannot change the display order without
> invoking the bug. I
> >changed the display order right off the start because I
> found the default
> >order too unworkable. Looks like I may be stuck with it
> again, or I put up
> >with the display problem which in my case is livable but annoying.
> >
> >Brad Velander,
>
>
> Brad,
>
> My experiments suggest that it is the "Default" button that
> causes the
> problem. I could use the Promote and Demote buttons OK. But
> I must admit
> I am not sure how much testing I did.
>
> Thinking about the different buttons in the Layer Drawing
> Order dialog, I
> can understand how an oversight (being polite) might make the Default
> button only fill the list with the old layers in a hard coded
> order (as
> this section of code was not updated when the new layers were
> added). I
> would be surprised if the Promote and Demote buttons cause
> the problem.
>
> Bye for now,
> Ian
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *